If you're importing a very basic G-code file, using the actual tool diameter may save you steps.If you're going to be working with pockets and such, it's often easier to choose a small value so your imported paths show up as lines and are easier to distinguish.On the Path menu, choose Union (Ctl-+) to merge the pieces into one outline.For V-carves, this is actually quite easy. Now you need to turn it back into something resembling the original geometery. The arcs will be broken up into line segments so they can be converted into SVG path data. If your V-carve G-code has G2/G3 arcs (you can open it in Notepad++ and just search for G2 and G3), you'll need to choose a curve interpolation step size.Generally, this is zero, but if the G-code is zeroed to the table not the top of the stock, you'll need to enter that. Choose the right value for the top of your stock.Using too small an angle will make everything deflate, and you'll end up with spikes instead of corners.Using too large an angle will make everything inflate and break, and you may even get a message if it breaks the math.This is the included (full) angle, so if the tip cuts a 90-degree V, enter 90, not 45. Turning it back into something worthwhile may be a bit more work, but in many cases a good result can be reached without too considerable an effort.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |